Ademco 5878 installer

Most of these are free resources that anyone can access, allowing you to download a copy of almost any alarm manual you might need. See my Alarm System Manuals page. Before visiting any potential manual source, you should check the model number of your panel. Most Ademco systems operate and program in similar ways, but there are differences depending on the specific model.

Trying to navigate through instructions or programming using the wrong manual can be very frustrating, and could cause you to alter the system operation in unexpected ways. If you already know your Ademco system model number, scroll down to the bottom of this page and click on one of the highlighted links.

Ademco alarm panels, as well as most other brands, normally have the model information on a sticker inside the lid of the main panel box. It will probably be tucked away in a closet or laundry room, and may or may not have a locking lid.

It will be smaller than a house key, with teeth cut on only one side. Once the lid is open, locate the panel information. Ademco has been making alarm equipment for a long time, so there are many, many different models. Most Ademco alarm systems will have at least two manuals available.

Here is what to look for:. These Ademco manuals will usually contain "Install" in the title or file name. This is everything an alarm technician or do-it-yourselfer would need to install the panel, connect it to power, a phone line, and other alarm devices.

Wiring information for keypads, zone expanders, and optional modules is also included. The "Install" file may also contain programming information see below.

Technical specifications are also listed, along with a wiring diagram of the panel. A Vista 20P schematic diagram is shown below, as an example.

Look for "User" in the file name or title. User manuals provide instructions on how to arm, disarm, bypass zones, etc. Keypads that come out later may have an addendum to the user manual, explaining their operation. Look for "Program" in the file name. This includes entering zone definitions, account number, dialer information, master codes, etc. Even after a system is installed, programmed, and working, the programming guide is necessary when making any future changes to the system.

Note: Buttons on this transmi tter must be pre ssed. This feature minimizes the possibility of accidental. If P rogra mming 4E in the Co ntrol. Program the button in the control. Af ter pr ogra mming is compl ete , exit. Press all 4 buttons on the E at the same. T o sync the devi ce in High Secu rity Mode ,. Figu re 1: E showin g butt on design ations. Hold all 4 buttons dow n w hile enrolling the serial. Enroll the 4E into the re ceivers one at a ti me,.

Then , disconnect Re ceiver 1, reconnec t. Receiver 2 , and repeat the enrollment procedure. This proces s ensures proper High Se curity. The E is suppl ied with colored but tons red. Each label has. To paste a label on a butt on, slow ly peel off a.